The panel has four major support ribs at 1.25” high that add rigidity and strength to the panel. The shear can operate at high or low speeds for the control you need to follow a precise cut line. ‘ Miami-Dade County, Florida Approved - See Approvals for Requirements 254-246-4064 CONTACT US. Below is a list of all of the R-Panel system approvals and certifications. Heavy-duty gearing and beefy, hardened carbon steel blades combine to offer long service life in 30 to 24-gauge (0.31 – 0.61 mm) roofing panel metal. They tested Wick Agri Panel, Midwest Manufacturing, Grandrib 3, Walters STR-28, Metal Sales Pro Panel II, McElroy Metal Max Rib and Alumax Power Panel. The action of a single cut shear is essentially the same as a pair of scissors (or shears, for that matter). Store Hours M-F: 7:30am – 5:00pm Saturday: 7:30am – 12:00pm Stephenville 3030 Northwest Loop Rd Stephenville, Texas 76401. The first floor panel experiences no reduced shear capacity or “R” value due to the second story panel load. National Frame Builders Association has done extensive testing on the type of roof and wall panels which we are discussing, and they have good diaphragm and shear wall capacity. NEW 16 Station PBR – R-Panel Roll Former; 36″ panel, ribs on 12″ centers, 1 1/4″ high coil width 42 3/4″-43″ USA Tooling Design – Special Roll set in stand 16 – by adjusting the stand tighter it will reduce the width of the panel, looser it will make the panel wider so the exact panel width of 36″ may be achieved even with variations in coil strength. Panel heights or vertical load from above causing the need for an EC6 or EC8 option? The R-Panel system is available in 36” coverage. The shear can operate at high or low speeds for the control you need to follow a precise cut line. Since panel widths and locations can be independent of one another, design flexibility is almost limitless. Single Cut Shears Single cut shears like the Makita JS3201 are suitable for heavier duty work. Hardened carbon steel blades combine to offer long service life in 30 to 24-gauge (0.31 - 0.61 mm) roofing panel metal.